JSON-LD markup generated by Google Structured Data Markup Helper.

Go to…

Dodge

Home / Dodge / Page 2

We Service and Repair all Dodge cars

  • 2004 Dodge Dakota

    Dodge Dakota
    Mileage
    185,191
    Service Date
    11/11/2021
    Services Performed
    • FOUND COOLANT LEAKING OUT OF RADIATOR (CRACKED TANK ON LEFT SIDE). RAN 5GAS ANALYZER, FOUND NO BLOWN HEAD GASKET. NOTED CLUTCH FAN DOES NOT FULLY ENGAGE. RECOMMEND: RADIATOR THERMOSTAT FAN CLUTCH
    • REPLACED RADIATOR
    • REPLACED THERMOSTAT
    • REPLACED FAN CLUTCH. FAN IS LOUD, THE FAN CLUTCH DOES HAVE BREAK-IN PERIOD, SHOULD GET QUIETER. THE OLD FAN DID NOT MAKE ANY NOISE DUE TO THE FAN CLUTCH NOT WORKIING.
     
    TOM I. gave our service a 5 star review on 11/12/2021

  • 2017 Dodge Journey

    Dodge Journey
    Mileage
    59,630
    Service Date
    10/11/2021
    Services Performed
    • FAULT TRACE SYSTEM: _po456_____ CODES RETRIEVED: scan vehicle and retrieved po456 small leak detected base smoke tested event system and found leaking at gas Recommend to replace gas And further testing
    • Change oil and oil filter. Check air filter and breather filter. Top off all fluid levels and set tire pressures. Preform basic Vehicle inspection OIL LEVEL WHEN CAR CAME IN. full full performed oil change and 40 point inspection.
     
    Daryeo L. gave our service a 5 star review on 10/29/2021

  • 2004 Dodge Dakota

    Dodge Dakota
    Mileage
    181,881
    Service Date
    2/22/2021
    Services Performed
    • 40 POINT AAA INSPECTION
    • Change oil and oil filter. Check air filter and breather filter. Top off all fluid levels and set tire pressures. Preform basic Vehicle inspection OIL LEVEL WHEN CAR CAME IN ____3 qts low_____
     
    TOM I. gave our service a 5 star review on 2/22/2021

  • 2013 Dodge Avenger

    Dodge Avenger
    Mileage
    113,319
    Service Date
    9/2/2020
    Services Performed
    • FOUND CODES: P0325 KNOCK SENSOR 1 CIRCUIT P0335 CRANKSHAFT POSITION SENSOR CIRCUIT P0552 ENGINE OIL PRESSURE SENSOR CIRCUIT LOW FOUND CKP SENSOR HAS 5 VOLT REFERENCE, USED LAB SCOPE AT CRANK AND CAM SENSOR (NO SIGNAL FROM CRANK SENSOR GOOD SIGNAL FROM CAM SENSOR. SCANNER HAS CRANK SENSOR FAULT WITH NO SYNC. RECOMMEND CRANK SENSOR OIL PRESSURE SWITCH (FACTORY PART) THEN RE-TEST SYSTEM WILL NEED TIME TO REMOVE INTAKE TO GET TO KNOCK SENSOR RE-TESTED SYSTEM AFTER ENGINE RUNNING OIL PRESSURE SWITCH WORKING AND KNOCK SENSOR WORKING HAS .25-.31 VOLTS AT IDLE (0-5 RANGE).
    • FOUND FRONT CRANK SHAFT SEAL LEAKING RECOMMEND: FRONT CRANK SHAFT SEAL.
    • REPLACED CRANK SENSOR.
    • REPLACED FRONT ENG. SEAL, TOPPED OFF OIL, AND LEAK TESTED. FRONT BUMPER AND UNDER COVER DAMAGED.
    • REPLACED OIL PRESSURE SWITCH.
     
    MAX D. gave our service a 5 star review on 9/2/2020

  • 2004 Dodge Dakota

    Dodge Dakota
    Mileage
    178,860
    Service Date
    8/3/2020
    Services Performed
    • Change oil and oil filter. Check air filter and breather filter. Top off all fluid levels and set tire pressures. Preform basic Vehicle inspection OIL LEVEL WHEN CAR CAME IN _____FULL______________
    • FOUND WATER PUMP BEARING EXTREMELY LOOSE. UPPER AND LOWER RADIATOR HOSES APPEAR ORIGINAL. BELT CONTAMINATED WITH COOLANT RECOMMEND: WATER PUMP BELT TENSIONER UPPER RADIATOR HOSE LOWER RADIATOR HOSE COOLANT
    • REPLACED SERPENTINE BELT TENSIONER AND BELT.
    • REPLACED WATER PUMP AND UPPER AND LOWER RADIATOR HOSES, PRESSURE TESTED AND TEST RAN ENGINE.
     
    TOM I. gave our service a 5 star review on 8/4/2020

  • 2014 Dodge Dart

    Dodge Dart
    Mileage
    80,862
    Service Date
    4/30/2020
    Services Performed
    • (Combination) – ELECTRONIC POWER STEERING SYSTEM – Calibrate Clear Steering Pull Compensation Procedure – [Includes: Scan Tool and Road Test.]
    • BACK UP CAMERA NOT WORKING MOST OF THE TIME, CHECK AND ADVISE
    • RACK & PINION HARD TO TURN RIGHT. RECOMMEND RACK & PINION , ALIGNMENT REQUIRED WITH THIS REPAIR. RIGHT WHEEL BEARING MAKING NOISE, RECOMMEND BEARING AND HUB. BUMPER COVER DAMAGED.
    • STEERING GEAR – Remove & Replace – All Applicable Models – [Includes: Adjust toe-in on Rack and Pinion type Steering Gears. NOTE: Deduct .4 if alignment is also performed.]
    • WHEEL HUB – Remove & Replace – Front,One Side
    • Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check caster and camber angles and adjust as required. Check and set toe-in as required. Center steering wheel. TIRES SHOWING ABNORMAL WEAR?
     
    JACOB M. gave our service a 5 star review on 5/7/2020